Install Shower In Basement Concrete Floor : Basedhomed

Install Shower In Basement Concrete Floor

Installing a shower in a basement concrete floor can be a challenging but rewarding project. By following these steps, you can ensure a successful installation.

Materials you’ll need

Concrete saw
Electric drill
Hammer
Chisel
Screwdriver
Level
Measuring tape
Shower liner
Tile backer board
Tile adhesive
Grout
Shower drain
Shower head
Handles

Step 1: Prepare the concrete floor

Begin by preparing the concrete floor. Use a concrete saw to cut a hole in the floor for the shower drain. The hole should be at least 2 inches (5 cm) wider than the drain flange. Next, use a hammer and chisel to remove any debris or old flooring from the concrete surface.

Step 2: Install the shower drain

Place the shower drain in the hole and secure it with screws. Apply a bead of silicone caulk around the drain flange to ensure a watertight seal.

Step 3: Build the shower curb

To create the shower curb, use cinder blocks or concrete blocks. Stack the blocks around the perimeter of the shower area, leaving a space for the shower door. Secure the blocks with mortar or concrete adhesive.

Step 4: Install the shower liner

Spread a layer of shower liner over the concrete floor and up the walls of the shower area, overlapping the curb by at least 6 inches (15 cm). Use a utility knife to trim any excess liner.

Step 5: Install the tile backer board

Cut the tile backer board to fit over the shower liner. Secure the backer board to the concrete floor and walls with screws or nails. Ensure the backer board is level and flush with the shower curb.

Step 6: Install the tile

Apply a layer of tile adhesive to the back of each tile and press it into place on the tile backer board. Use a level to ensure the tiles are even. Space the tiles evenly apart using tile spacers. Allow the adhesive to dry completely.

Step 7: Grout the tile

Once the tile is dry, apply grout to the joints between the tiles. Use a grout float to spread the grout evenly and remove any excess. Allow the grout to dry completely.

Step 8: Install the shower head and handles

Attach the shower head and handles to the shower wall according to the manufacturer's instructions. Seal around the base of the shower head and handles with silicone caulk.